Termite Control Centurion for Dummies
DO NOT waste lure by adding it to timbers which do not contain live termites. The colony is killed only if employees take enough of the bait back to the nest. And they'll only take it if they can harvest it, undisturbed, from inside the ruined lumber you've found. .
See the uneven surface of the window frame. Termites had eaten it out, in certain regions leaving only the paint.
About Termite Control Centurion
Make an opening into the termites using a pointed knife or fine screwdriver. The hole should be no larger than about 5mm diameter to begin with. (It should be enlarged only when it's time to add the cache of bait). You can pry into the surface of the wood where it seems spongy, thin or hollow.
It is only as a last resort you should make an effort to open a tunnel on a wood or foundation surface. .
Once you've broken into into where it's hollow, wait for a minute or so. If termites are not there, the soldiers usually come to guard the opening while employees repair it. You will see their antennae and their heads blocking the gap. If no live pollutants appear, leave the hole open and return later or check next moment.
The 3-Minute Rule for Termite Control Certificate
This shows how termites will come out from the infested timber into a foil covered mass of lure taped into the surface. Alternatively, if the surface is flat, the feeder may be fixed over the pit and the termites will enter it to harvest the lure.
If the wood has a flat surface, make the hole away from corners so that you can line it up with the hole in the bottom of the feeder. If the access hole to the termites is on a round pole or another situation where you cannot fix the feeder to it, you can earn a pouch of aluminium foil and duct tape to hold the bait in place.
If you are using the foil method, carefully pull the edge of the sticky tape to inspect and to replenish the bait. If you are using the feeder system, it is not as disturbing if you can add more bait to the original feeder.
The termites you will see as dark brown nests high up in a tree are rarely pests of significance. But the main subterranean termites which do that 99% of the $damage we mentioned earlier, will often nest inside the central pipe or even hollowed out heart of a tree. Mastos, the giant northern termite, dont always await the decay of this pipe.
Examine This Report about Termite Control Certificate
(See the special box on Mastos).
If at colonising flight period a termite couple find their way into a hollow tree through maybe a dead/broken-off branch or in through a scar from flame at the bottom they could not possibly have better conditions. Theres plenty to eat, moisture and protection. A 50 metre travel to your home would not be out of the question. .
In case you've got a large eucalypt, peppercorn or a http://www.innovativepestcontrol.com.au/ mature fruit tree nearby, you should check it. Use an 15-20mm auger bit long enough to drill into the centre of the trunk at about shoulder height. Drill at a slight downward angle and when you are feeling less resistance it will be because you achieve the pipe.
Getting My Termite Control Certificate To Work
If not, you could slip in a long thin grass foliage into the drill hole, then leave it there for a minute and withdraw it gradually. Termites might be found holding on, attacking it. If still no live termites are found, come back in half an hour or next morning; if there's termite lifetime inside, they will be repairing or have repaired the opening using their sand mixture. .
In this situation you dont need to view live termites; its only more satisfying to know you have actually killed a colony when you choose the next steps
Re-open the drill hole when it's been repairedUsing a funnel, plastic tube and watering can/bucket, pour at least 20-30 litres of a chlorpyrifos or a bifenthrin solution down into the tree. These insecticidal concentrations can be bought by a local hardware shop. They could be known by various brand names but the active ingredients are on the front panel of the label.